Main advantages of the process:

• High degree of application flexibility
• Close thickness control tolerances for thin coatings
• Possible re-use of over-spray
• Process can be fully automated
• Rapid post application fusion (lower heating temperature than with fluidisation)
• Masking and selective coating possible
• Smaller inventories of powder are required by the coater

Fluidized Bed

Main advantages of the process:

• Coating of parts with complex geometry with uniform coating thickness
• External and internal coating in a single operation
• Highly flexible in terms of part dimension
• No need of post-curing
• High production rates
• Limited powder waste

Hot/Flock Spraying

Main advantages of the process:

• No limitation in term of part dimension and geometry
• Good flexibility
• Low investment in equipment
• No need of post-curing

Mini / Maxicoating

Main advantages of the process:

• Fast and easy coating of small parts in large numbers
• Limited handling of piece